The Lingenfelter TRG-002 module allows Gen IV GM V8 engines with the 58x crankshaft trigger or reluctor wheel and the 4x camshaft timing gear to be installed in earlier vehicles designed to accept the 24x crankshaft trigger wheel and the 1x camshaft trigger wheel without having to take the engine apart to change the cam timing gear or the crankshaft reluctor wheel.
The Lingenfelter TRG-002 is a plug-and-play design that connects directly to your existing wiring harness and to the factory engine sensors and has its own power source harness. Some early Gen IV V8 engine equipped vehicles that will need a camshaft sensor extension harness.
TRG-002 Key Features
Fully encapsulated (potted) construction for increased durability
High temperature glass filled Nylon low profile case
Transient voltage and over voltage protection have been incorporated into the design to accommodate the ever increasing electrical demands of modern vehicle control systems.
NOTE: This module is only designed for a newer engine with a 58x crankshaft trigger wheel and 4x camshaft trigger wheel going into an older 24x vehicle. It will not convert the 24x crankshaft trigger signal to a 58x crankshaft trigger signal and no module exists to do this. You must physically change the reluctors in the engine.
NOTE: This module does not work with front wheel drive LS applications.
LS 2 Bar MAP Sensor (Early - LS1, LS2, L76 & L98) P/N: 2BAR-LS
Suitable for all LS Engines
Direct Fitment for VT Commodore LS1 through to Early 2010 VE Commodore.
LS 2.7 Bar MAP Sensor (Late - L77 & LS3) P/N: 27BAR-LS
Suitable for all LS Engines
Direct fitment for Late 2010 VE Commodore Onwards.
LS-1 Air Temp Sensor P/N: IAT-LS
VE V8 Mafless Air Temp Sensor Adapter Loom P/N: IATLOOM-VE
Length - 300mm
VZ V8 Mafless Air Temp Sensor Adapter Loom P/N: IATLOOM-VZ
Length - 300mm
Suitable for
VZ LS-1
VZ LS-2 HSV
Electronic Throttle Body Extension Loom P/N: TBODYLOOM-VE